Welcome To Hotrodders
Tech Help
General Hot Rod Forum Discussions
Knowledge Base
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
I needed taller rocker covers to clear full roller rocker arms I installed. I was planning to run the stock accessory drive from a 94 B body LT1. This is a serpentine belt system. The Alternator won’t clear the new rocker covers so I’m designing my own accessory drive system to run power...5 replies 110 views
-
1950 Ford Shoebox Resto-Rod I need to cut out a section of my trunk floor about 12"x12" to gain access to replace the fuel tank sending unit, which is on the top. This is a custom car and the previous owner/builder tack welded a bracket from the tank to the body. So dropping the tank is not...0 replies 0 views
-
Will vortec heads from a 880 Chevy 350 be used on a 638 Chevy 350. Bolt patterns match perfectly. What are the pros n cons.0 replies 0 views
-
Hi rodders crowd, I came back from a car show last Saturday and was doing 60mph on the freeway in the slow lane when all of sudden a large thumping and cracking sound came from the rear of my modified '29 Ford Model A. It has a 8" ford rear-end with drum brakes and the tire/rim including the...2 replies 36 views
-
I'm currently reviving a 1968 Corvette 350 cu.in 300 H.P. It currently has a TH400 transmission installed which shifts perfectly, but does not have the Overdrive gear or the Torque Converter Lockup. I have already modified a TH700R4 for my 1934 SBC 350 cu.in. street truck, and it has shifted...118 replies 18K views