Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - modifying a fwd cars strut tower for turbo clearnce - advice needed
View Single Post
  #4 (permalink)  
Old 03-10-2006, 12:41 PM
lowROLLERchevy's Avatar
lowROLLERchevy lowROLLERchevy is offline
... & Insanity Ensues .....
 
Last wiki edit: The FREE T Bucket plans Last photo:
Join Date: Jan 2004
Location: Western NY
Age: 34
Posts: 937
Wiki Edits: 22

Thanks: 0
Thanked 0 Times in 0 Posts
i could build a notch out of plate, but i was considering doing it this way due to the heat off the exhaust pipe, i dont want to go baking the paint.

since the plastic wheel sheild is just the other side of the sheet metal, it will have to be trimmed , and i would simply replace that section with some sheet metal

this car is definantly going to require some creative pipe work, but it was hard to consider everything when i was loking at the car, its in storage on a muddy gravel lot, so i couldnt jack it up .... i dont have that sort of a death wish

plus few of the parts have been bought, so i had nothing to mock up
Reply With Quote