|
Ok well you just gave me a new idea with the tabs and the bolts. I have a welder and know how to weld so all that part isn't a big deal to me and can be easily done. I will try and get some pictures of the seats and load them up tonight. Check back on tonight and I should have a few pictures of the seats themselves, the tracks, brackets, etc. I think any route I go will be better than what I have now. The stock bench seat is only held in by 4 bolts to the floor and that's it and right now I only have 2 in there holding it down which is a stupid and bad idea but I couldn't get the other one's to thread in right and thought I'd leave it for now since I will be putting these bucket seats in.
Thanks for the help though man, I am going to go out there, take the bench seat out and see what the best plan to go by will be.
Thanks a lot!
|