Hot Rod Forum banner

Mounting my engine in the chassis

592 views 3 replies 2 participants last post by  Quarter Flash 
#1 ·
Recently I had more time than money and got bored, so I set my engine back another 4.5". This ment I could redo my engine mounting system better. I will be adding a link from the blk center engine mounts to the front crossmember. This will help keep the engine from moving front to back in a hard launch.

Take a look at the pics

Bob
 

Attachments

See less See more
5
#4 ·
Drag Car

It's a drag racing car. This is my first project car of any kind. I did not know about this site until I was half done with the car so most of it I figured out my self. I don't claim it's right because I am an armature. I am hoping the car will run low tens or high nines in the quarter mile. I have had a NHRA chassis inspector view the pics along the way and make suggestions. Also Jeg's has been a great help. Check out my project journal.

Bob
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top