Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - moving 610lb compressor
View Single Post
  #2 (permalink)  
Old 10-20-2009, 12:52 PM
heyjude076 heyjude076 is offline
Registered User
 

Last journal entry: Bringing home the 401 Nailhead
Last photo:
Join Date: Jul 2006
Location: NE Ohio
Posts: 381
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by Delacy789
The trucking company just dropped off my 2 stage air compressor weighing in at 610lbs. Its now sitting on a pallet in the driveway. Anyone know how to move one of these things into the garage?
Use pipe as rollers. I use 1/2 gas pipe but even conduit will do. Pry one end of the pallet up and slip a piece of pipe under it. Make sure your pipe spans the entire width of the pallet. Then use a pry bar or maybe just push. It will roll on the pipe toward your destination. I use two or three pieces of pipe. As your pallet rolls up on one place another in front and keep going.
Reply With Quote