Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - MSD Ignition questions
View Single Post
  #1 (permalink)  
Old 11-24-2012, 09:40 AM
Aaronk227 Aaronk227 is offline
Registered User
 
Join Date: Nov 2012
Posts: 4
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
MSD Ignition questions

Yesterday we began running a couple initial engine checks on our new toy to make sure it was all good to go. One of the things we did included disconnecting the plug wire from the coil to the distributor cap and cranking the engine. During this test the coil arc'd to the firewall, but we didn't think anything of it.

After we were all done with tinkering, we went to the start the car and there is nothing coming out of the msd 6-btm box. We followed the instructions on MSD's website and have determined that the box is not working.

My question is, is it possible that this arc could have somehow shorted this box out? Is there some sort of fuse or reset switch anywhere? We are just a little shocked that this component could have gone bad so easily.
Reply With Quote