Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Are Mustang II Crossmembers Safe?
View Single Post
  #10 (permalink)  
Old 10-17-2003, 08:55 AM
Tony@AirRideTech Tony@AirRideTech is offline
Last photo:
Join Date: Jul 2003
Location: Indiana
Posts: 296
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
The most important factor in this whole equasion is "Who is welding what to what"..............

Originally posted by Jon
What sent up a red flag for me was Heidt's response letter, in this thread. It's full of PR doubletalk, and comes across as an attempt to do some damage control. The way he's presenting the statistics on the number of failures leaves much to be desired.

I spoke with Fatman Fabrications on the phone at length. I was polite and diplomatic. They were cagey, rude, and defensive. If they're willing to discuss it, then I feel that they should have responded to my email and phone requests to address the issue in a public forum.

Tony -- maybe you can put in a good word for us with some of these MII manufacturers, or drop them a line and invite them to join in the discussion?
I hear what you are saying and to a point I will agree with you but I would also side with them for not coming into a discussion over an internet chat board. You could basically be inviting them to a hangmans party. With the number of shady internet users out there a conversation on a chat board can be very one sided.

Last edited by Tony@AirRideTech; 10-17-2003 at 08:55 AM.
Reply With Quote