Hot Rod Forum banner

Mustang II front end bushing question

2K views 6 replies 6 participants last post by  Trophyman 
#1 ·
Note the arrow in the picture. What's the deal with the serrations?

I'll be breaking down the chassis soon and I had a look at the front end. I've never dealt with a MII before. It looks like the rubber bushing wants to be aligned pretty close to where it'll sit for the rest of its life before tightening, hence the serrations on the shaft. correct?

I was hoping to take this stuff apart. Can I get the bushings out of the upper, or should I leave well enough alone and paint the best I can with the cross bar in place? No biggie either way, but..... I hate getting paint on rubber and masking in there will be an inexact proposition.
 

Attachments

See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top