Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - "Mustang II" power steering hose fitting sizes
View Single Post
  #7 (permalink)  
Old 12-20-2010, 09:54 AM
fleetsidelarry's Avatar
fleetsidelarry fleetsidelarry is offline
Registered User
 
Last photo:
Join Date: May 2006
Location: shellmanbluff, GA
Age: 69
Posts: 22
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Just a follow-thru to close this out (I hope). I could get all the AN fittings and high-pressure hose to make a new line from Speedway for about $50 or their already made-up kit for $92. Nobody within a 40 mile radius would make me up one with the exception of one guy who would IF I brought him the proper ends. $30 PLUS the cost of a new hose to rob the end off of, so still around $50.

I talked to Gil at Borgeson (http://www.borgeson.com/catalog.html#) who said if I had the rack that mounted on 15 1/5" centers it was the newer rack which took the metric fittings, 14 mm O-ring pressure side. My old rack was an 'old' rack (mounted on 16" centers) which took the 5/16 male O-ring.

For $75 I ordered his hose kit which should be here by Thursday (depending of course, on how many blizzards hit between here and Connecticut in the mean time).

Thanks to all who responded.
Reply With Quote