|
|
|
12-20-2012, 02:00 PM
|
||||
|
||||
|
my 350 turbo transmission
I just replaced my transmission pan and Seal and put 5 qts in it I also let it worm up and put it through the gears and it shows up just above the add mark on the stick do I need to put a 6th qt in
|
|
12-20-2012, 02:27 PM
|
|||||
|
|||||
|
I would add about 1/2 qt. take it for a short run after it's up to temp. then check it when you return .. add if needed .
|
|
12-20-2012, 02:37 PM
|
||||
|
||||
|
Ok I will do thanks I aslo have another question the new pan and seal are still leaking not bad I tightened all the bolts n don't know were to go from there
|
|
12-20-2012, 03:06 PM
|
|||||
|
|||||
|
your talking about the pan gasket . correct .. never over tighten the pan bolts.
I can't see the pan gasket leaking unless was installed with a sealer on it .. I use 3M spray glue on the pan side of the gasket .. let it tac and put it on .
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help for transmission yoke for turbo 350 | eric32 | Transmission - Rearend | 8 | 04-28-2009 08:58 PM |
| Turbo 350 Transmission leak | wfd102 | Transmission - Rearend | 2 | 09-01-2007 01:47 PM |
| Turbo 350 Transmission | my59f100 | Transmission - Rearend | 0 | 07-17-2003 06:22 AM |
| 350 turbo transmission | nelson350ss | Transmission - Rearend | 5 | 03-20-2003 04:22 PM |
| Turbo 350 Transmission Leaking | 63 vette | Transmission - Rearend | 2 | 02-19-2003 05:02 PM |
