Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - is my drive shaft too short?
View Single Post
  #1 (permalink)  
Old 08-18-2002, 07:48 PM
crebo crebo is offline
Registered User
 
Join Date: Aug 2002
Location: San Antonio
Posts: 1
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Question is my drive shaft too short?

Hi, I have a heavily modified 1959 chevy apache truck. It has a small block 350 and I just put in a new Jegs th350 transmisssion. I had the drive shaft balanced and new u-joints put in. When I put the drive shaft back on, I noticed that the slip yoke only goes into the transmisson about 3/4". It seems like it should go in a little further, but I'm not sure? The previous transmission was also a th350 and the dimensions are the same. I test drove it and it seems to work fine, but I would hate to mess up the new trans I put in...
Reply With Quote