I've taken my gearbox apart for rebuilding, and need to check things out before rebuilding it
Since this is the first gearbox I've rebuilt, and I have no idea what I'm looking for I'm hoping someone can tell me what I should look out for?
ie: What are and aren't acceptable levels of wear, etc....
Now, on with the pictures.......
This is the end of the mainshaft, it looks as those the hardening has worn through to me (but I don't know what I'm talking about so I could be wrong)
Here you can see a small chip out of the first gear
This pictures shows some wear on the teeth, I've pointed out the worst one, but you might be able to see the others have wear too
Another chip, this one is on the reverse/selector hub
Another picture of first gear
And some general/overall pictures
So, what does everyone think?
Do I need a new first gear and selector hubs?
Is my mainshaft scrap?
I was planning on replacing the baulk rings and circlip on third gear, but I've heard the new ones are awful
What should I do about the input shaft?
Any other thoughts?