Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Project street rod Bronco
View Single Post
  #8 (permalink)  
Old 07-31-2010, 05:01 PM
OneMoreTime's Avatar
OneMoreTime OneMoreTime is offline moderator
Last wiki edit: Health and safety in the shop or garage
Last journal entry: Yard Dog pic
Last photo:
Join Date: Jul 2004
Location: Washington State
Age: 72
Posts: 8,841
Wiki Edits: 3

Thanks: 220
Thanked 459 Times in 410 Posts
it is your choice however if I had in hand a rear already narrowed that was close enough then I would use it..the idea of scribing a center line and center lines of the axles on the garage floor is a good one..i use a plumb bob to line with to the center but then I am an old guy..also measure from suspension mounting point when squaring the chassis as frame rails can be a bit off..

I have tried most all of it and now do what is known to work..
Reply With Quote