Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - need cam suggestions for my 383 build
View Single Post
  #1 (permalink)  
Old 12-22-2004, 12:35 PM
TCAMARO TCAMARO is offline
Member
 
Last photo:
Join Date: Sep 2004
Location: NY
Age: 50
Posts: 87
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
need cam suggestions for my 383 build

The car is a weekend cruiser. Do not drag race but I do drive the car hard occasionally. The car is show quality. I want enough vaccum to run all accesories.

I plan to go with a solid flat tappet.

With that being said - the basics of my build are as follows:
383 stroker
10.0:1 compression
AFR 195 cc heads
RPM Air Gap intake
Hooker super comp headers 1 3/4"
Dr gas X pipe 3" into X 2.5 out
Muncie M20 4spd
4:10 rear
26" tall tire

The cam in my current 355 is a hydrolic 230/236 @ 50 , 487/490 lift all on a 110. I have 1.6 rockers on the intake.
I like the this cam for my 355 so I would like something similar. This cam comes in aroun 2,200 and pulls to 6k.
Reply With Quote