Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - need HEI measurement on SBC
View Single Post
  #3 (permalink)  
Old 04-07-2003, 02:57 PM
PrimeMover's Avatar
PrimeMover PrimeMover is offline
Sittin' on top of the world...
Last photo:
Join Date: Dec 2002
Location: Portland, Oregon
Age: 65
Posts: 467
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts

Installed height, complete with Accel coil is eight and a half inches. That's measuring from the intake manifold next to where the distributor drops through, to the top of the coil. If you do not run a Crossfire cap, you'll have to allow room for a plug wire or two to pass behind the cap.

Happy fabricating!
Reply With Quote