Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Need some advice on new set of aluminum valve covers for sbc
View Single Post
  #1 (permalink)  
Old 06-08-2010, 04:20 PM
eric32 eric32 is offline
Registered User
 
Last photo:
Join Date: May 2008
Location: ohio
Posts: 1,603
Wiki Edits: 0

Thanks: 50
Thanked 66 Times in 63 Posts
Need some advice on new set of aluminum valve covers for sbc

Hello guys I am looking into replacing my jegs chrome covers on my 350 sbc with a set of cast aluminum ones tall style but I want ones with good baffles that will keep my pcv valve from wanting to suck up oil. Does anyone have advice on a set that would be good but does not cost more then 80 bucks? I don't have a fortune right now to get something expensive and I feel I should have to pay over a hundred dollars plus for nice set. I was looking at these summit ones.

http://www.summitracing.com/parts/SUM-G3302/

Would those ones be a nice set? They do come with baffles and all I have to do is install them. I have what seems like good baffles in my jegs ones and they are all enclosed and they angle down like a slope with a hole at the bottom so oil that would get up in there can drain out. Anyhow hope people who have chevys and I know a lot does could offer some good suggestions and what would be a good set.
Thanks guys
Eric
Reply With Quote