|
|
|
06-08-2010, 03:20 PM
|
|||||
|
|||||
|
Need some advice on new set of aluminum valve covers for sbc
Hello guys I am looking into replacing my jegs chrome covers on my 350 sbc with a set of cast aluminum ones tall style but I want ones with good baffles that will keep my pcv valve from wanting to suck up oil. Does anyone have advice on a set that would be good but does not cost more then 80 bucks? I don't have a fortune right now to get something expensive and I feel I should have to pay over a hundred dollars plus for nice set. I was looking at these summit ones.
http://www.summitracing.com/parts/SUM-G3302/ Would those ones be a nice set? They do come with baffles and all I have to do is install them. I have what seems like good baffles in my jegs ones and they are all enclosed and they angle down like a slope with a hole at the bottom so oil that would get up in there can drain out. Anyhow hope people who have chevys and I know a lot does could offer some good suggestions and what would be a good set. Thanks guys Eric 
|
|
06-08-2010, 04:03 PM
|
||||||
|
||||||
|
|
|
06-08-2010, 06:05 PM
|
|||||
|
|||||
|
http://swspecialties.com/v-web/produ...mages/6030.JPG
oops, that was just the pic try the link below . . . Got some pulleys from these guys, pretty nice.. $ 60 valve covers http://www.swspecialties.com/valvecovers.html
|
|
06-08-2010, 06:07 PM
|
||||||
|
||||||
|
I got these off of Fleabay for right around $80. They have good baffles. Search finned valve covers there:
|
|
06-08-2010, 06:14 PM
|
||||||
|
||||||
|
Quote:
I love the look of finned valve-covers. Those are some good looking covers will they clear the aftermarket rockers ? Cole
|
|
06-08-2010, 06:31 PM
|
||||||
|
||||||
|
Those are the short ones. They sell tall ones as well. You'd have to ask the seller if the tall ones clear roller rockers.
|
|
06-08-2010, 06:35 PM
|
|||||
|
|||||
|
Well guys thanks for the nice options. I will have to look around some more then decide. On tall valve covers are they all pretty much the same tall height wise? Reason I ask is because my engine is in a chevy s10 with tall valve covers and anthing taller then what I got would be too much but I do have some but very little room left. I have to use tall ones cause of full aluminum rocker arms. Thanks guys
Eric
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum heads, now valve noise? | sandiegopaul | Engine | 13 | 04-21-2009 03:19 PM |
| Save an old set of stock valve covers. Why you ask? | Crazy Fast on Ice | Engine | 19 | 10-02-2008 04:15 PM |
| Valve Covers - Aluminum vs. Chrome | fleezy | Engine | 17 | 07-25-2006 08:24 AM |
| Valve covers...orange or aluminum? | wickster | Engine | 7 | 02-27-2005 11:40 AM |
| GM fast burn heads | batman09 | Engine | 1 | 10-26-2004 09:32 AM |
