Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - New MIG - unstable arc
View Single Post
  #4 (permalink)  
Old 01-28-2007, 06:50 AM
zimaad zimaad is offline
Member
 
Join Date: Jul 2005
Location: Virginia
Posts: 44
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
I checked and it has 30 wire and .8mm/30 tip. I can pull the wire through the gun when I release the drive wheel. It is on a dedicated 20A line. My garage has a 30A/110V service running to it. I have that going to a double 15A breaker for lights, etc and a dedicated 20A circuit for my welder. The wire in it looks good. Definately solid, not flux. The polarity is setup according to the chart on it for MIG welding.(not flux) I'll try cranking it up in power then increasing the wire feed and see what happens.
Reply With Quote