Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - new sbc blowby
Thread: new sbc blowby
View Single Post
  #3 (permalink)  
Old 10-11-2011, 05:55 AM
CNC BLOCKS NE's Avatar
CNC BLOCKS NE CNC BLOCKS NE is offline
CNC Blocks Northeast
 
Last photo:
Join Date: Sep 2006
Location: NORTHEAST
Age: 54
Posts: 1,469
Wiki Edits: 0

Thanks: 1
Thanked 20 Times in 20 Posts
Quote:
Originally Posted by stegman
I have a fresh 383 stroker in my roadster and after tuning and general cam breakin with a couple of short drives iam getting some blowby with and without the pvc. i know i should get some until its broke in, but it seems a little excessive to me. i pulled the plugs and they look even and pretty good telling me no broke rings. could timing effect blowby, iam running 76cc heads on 8cc dome pistons with a compression ratio of about 10.5 on 93 octane. does anybody think race gas or 100 octane avfuel would help. total timing is only 32 advance. thanks agian........
Do a leak down test at TDC to see if there are ring seal issues, If your block was not plate honed it will be hard to get the rings to seal.
Reply With Quote
The Following User Says Thank You to CNC BLOCKS NE For This Useful Post:
1Gary (03-14-2013)