Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - NEWB Advice for My 1st 350 Rebuild
View Single Post
  #18 (permalink)  
Old 08-18-2010, 11:21 PM
frodin1 frodin1 is offline
Registered User
 
Last photo:
Join Date: Aug 2010
Location: Lake Havasu AZ.
Posts: 160
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Ahh, ok. I'm following you now! Thanks for all the advice. I wasn't sure if you guys were talking about stabbing the whole thing in, or doing a conversion. I wasn't even sure if the Vortec heads would even fit on this block or not. Some of the threads I found on "other sites" had some questionable advice. I think this sounds like a good way to head, and sounds like the best bang for the buck setup! I think I'm going to head to the machine shop on next week and have a chat with those guys, just to see if this is something they can handle. Apparently, there's only two shops here in town. My other option is Vegas, or Phoenix. I have the Quad carb already, and quite a few other items. I just need to check with the shop to make sure everything is ok. Awesome guys, thanks.
Reply With Quote