Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> 1980 turbo T/A Wont Start
User Name
Password
lost password?   |   register now

Thread: 1980 turbo T/A Wont Start Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-31-2001 10:01 PM
R2SPEEDRACER yep I agree with the other post internal combustion engines work because of FUEL < SPARK COMPRESSION<AND TIMMING TIMMING TIMMING check it bet you find the problem there
10-28-2001 04:19 AM
KULTULZ It could be a number of things;
[*] Does it backfire through the carb when it shoots gas?

1) It could either be flooded or the timing has jumped. After cranking for a few moments, open the throttle plates and look for puddled gasoline on the plenum (intake manifold) floor. If there is a large puddle, either the carb float is stuck or the carb bowl plugs are leaking. Make sure you also check the choke and choke pull-off for proper operation.

2) Check static timing by setting the timing mark(s) at TDC and seeing if the dist. rotor points to No.1 on the dist. cap.
[*] Make sure the battey is fully charged. Most ECM's (if you have a feedback carb.) need to read at least 12V for reference voltage for proper operation.

Just a couple of suggestions, but will give you a place to start.
10-27-2001 08:11 PM
mytransam
1980 turbo T/A Wont Start

any suggestions, I have Good Spark, and planty of Gas. The car turns over, and sometimes spurks gas out of the carb.

thank you
Jennifer

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:34 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.