Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Removing heads
User Name
lost password?   |   register now

Thread: Removing heads Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-20-2008 08:31 PM
DoubleVision I`ve seen in several cases where the rockers have to be clearenced so they don`t make contact. Usually a carbide cutter was used then checked and rechecked until enough clearence was created. Usually the contact shows up during the mock up assembly and all the rockers are checked. But I suppose it could have occured at a upper rpm blast. I can`t say I have heard of engine works stuff so I can`t give a opinion on them.
10-20-2008 08:24 PM
327NUT First of all you need to find out WHY the rockers were hitting the retainers, too much valve lift? rockers that aren't made properly...etc. I would say yes, you probably can smooth them out but I wouldn't take the chance, have them checked for proper ratio.

Also think about where the material is that used to be on the rockers????...circlating around through your engine? Yes you can reuse the standard nuts but why bother, they are very cheap. Polyloc's are reusable....and your last question...what isn't made in China.
10-20-2008 06:26 PM
Removing heads

I tore into my 383 sbc and discovered a few things and would like your opinions. First some of the roller rocker arms were making contact with spring/retainer and now the aluminum rockers have a small divot in them. Can I smooth these out with a dremel and reuse them? The divots are maybe 1/16th deep and again not on all of the rockers, I believe the contact probably was made when I had it wound tight 5500 plus??? Two can you reuse the rocker arm nuts/polylocks? Engine has less than 6500 miles on it. Has anyone heard of Engine Works products are they china stuff? Probably will have more questions this week so thanks for the help.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 03:27 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.