Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Truck bedside bottom edge stretched, how to fix?
User Name
Password
lost password?   |   register now

Thread: Truck bedside bottom edge stretched, how to fix? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-13-2009 04:46 PM
stepside If the bottom of the bedside was just bent then there is likely little or no stretching in that area. Although depending on how it was bent and the exact constraints of the panel you could end up with some stretched metal.

I think your best plan of attack would be work the metal off dolly, the objective here is to move the metal around and not stretch it. Hold the dolly behind where you don't want it to move and hit where you want it to move. The key is light taps if you start thrashing away you will not be satisfied with the results.

If you get to a point where you just cant seem to tune it in perfection you likely have some stretched metal and the best way to shrink and automotive body work is a shrinking disc. Do a search here and on metalmeet.com regarding the use of a shrinking disc. You could use a torch but it doesn't allow for the same controled shrinking that can be easily achieved with a disc.
Good luck
02-13-2009 03:35 PM
BIGSKY
Truck bedside bottom edge stretched, how to fix?

I am fixing the bed on my buddies truck and am having trouble with a bedside that has been bent up from the bottom. I have moved it most of the way back with my hands and some bad hammer work, but can't go any further because of the stretched metal I believe.

I am wondering if a heat and cool cycle will work here for shrinking or could I resort to slotting the metal with my cutoff wheel so I can move the bedside bottom edge back down then weld it back up? Red lines are where I thought I would cut it if that's what it takes.

Any opinions appreciated .

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:11 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.