Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> 30 coupe ft floor
User Name
Password
lost password?   |   register now

Thread: 30 coupe ft floor Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-20-2009 08:41 PM
MARTINSR Where to begin? Begin with some poster board and a pair of sissors. Honest, just cut yourself a pattern that will do what you want it to do. You may need to cut this pattern a half dozen times or more before you have the one you want, but it is a lot cheaper and easier than cutting metal!

Start with that, cut your pattern out then transfer that to metal and bend it to shape, that is all there is to it.

Brian
04-19-2009 11:43 PM
william r plise
30 coupe ft floor

Has anyone used the front floor from Speedway's for the recessed firewall on a 30/31 coupe. My coupe is sitting on So-Cal's pinched nose highboy frame and I installed their 4" recessed firewall and I need to install the front floor. The picture shows the floor flat with a bolt on hump for the tranny and two sides but my 350 is sitting above the floor height all the way back to the rear flange. Which means I will have to fabricate a tunnel for the center of the floor. Does anyone have journal pictures of a fabricated front floor. I want to use 16 gauge steel cuz I don't want to use wood but am not sure where to begain. Pops

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:45 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.