Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> 350 turbo shift issues.
User Name
Password
lost password?   |   register now

Thread: 350 turbo shift issues. Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-28-2009 08:58 PM
sqzbox Or, when you pull the vacuum line off of the modulator and fluid drips out, the modulator is bad.
08-25-2009 07:36 PM
eloc431962
Quote:
Originally Posted by 75gmck25
The vacuum line running down from the carburetor to the transmission modulator should have short rubber sections on each end, and be made of metal from the carburetor area down to near the modulator. An all rubber line may collapse and/or burn up where it runs near the exhaust manifold.

Bruce
Or it may have simply came un-hooked from the modulator. Cole
08-25-2009 07:31 PM
75gmck25 The vacuum line running down from the carburetor to the transmission modulator should have short rubber sections on each end, and be made of metal from the carburetor area down to near the modulator. An all rubber line may collapse and/or burn up where it runs near the exhaust manifold.

Bruce
08-24-2009 05:30 PM
Crosley Check your vacuum feed tube and hoses from the engine to the vacuum modulator on the trans
08-24-2009 05:25 PM
Heavychevy82
350 turbo shift issues.

350 turbo had some shifting issues as far as going around a turn it would not down shift.. Changed the fluid and filter.. Problems now.. I can put the truck in the drive position and it will move however it will not shift.. I have to crank it down to 1 and then manually shift it from there.. It will give me good shifts when I shift it at the correct rpm range.. I put too much fluid in at first.. I read that the trans holds about 8 to quarts. But what I did not realize that it was dry capacity.. My fluid capacity now from what I have read is four quarts.. I over filled by two quarts I put six in.. Experienced the problems got more knowledge and sucked the other two out.. I check the fluid now and it is at optimum level however it still shifts manual.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 04:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.