Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Final sealer fixes
User Name
Password
lost password?   |   register now

Thread: Final sealer fixes Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-25-2009 03:12 PM
bobyell sorry bad terminoligy , I did mean the catalyzed glaze putty. Although I hate using that stuff, it seams like it creates more work than it solves. But that is probably me. just wanted to be sure it is ok to putty then seal minor spots. i did try it and once its sanded you cant tell where i laid more sealer down.

Bob
09-25-2009 11:22 AM
cyclopsblown34 I wouldn't use the one step spot putty. I'd use a catalyzed glaze, it won't shrink later on down the road like the one step spot putty will. i would try and scuff the sealer a little bit to make certain the glaze has something to bite to.
09-25-2009 07:45 AM
bobyell Nobody ? I'll take a spin over to Robbins auto parts.

Bob
09-24-2009 07:32 PM
bobyell
Final sealer fixes

Hi guys,

I have used ppg dp50lf epoxy primer on the parts as the base primer. Once it was sealed I used a primer surfacer to get ride of sanding scratches etc.. When I was satisfied with the look and feel of the panel I put the final ppg seal coat over that. But I noticed that after I applied the final seal coat that some minor spots I missed appeared. Can I just use spot putty on the area and sand then reseal that spot only?

I intend on wet sanding the final seal coat with 600 grit paper to get rid of the minor orange peel.

You guys and this site have help me out a TON on how to paint and diagnose "gun issues" I can now spray with very little peel on the primers.

Bob

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:19 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.