Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> LSx engine into series III Jaguar XJ6
User Name
Password
lost password?   |   register now

Thread: LSx engine into series III Jaguar XJ6 Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-28-2010 03:15 PM
dhen
LSx engine into series III Jaguar XJ6

Hi everyone,

I'm new here and I'm doing research for a future project. I want to swap in an LS engine into a series III Jaguar XJ6 (1982-87). There is a guy who sells a kit for this swap so I'm not worried about getting into the car, but I'm not sure which engine I should use.

I realize that engine swaps are not cheap, but I'm still trying to stay within a reasonable budget ($5,000). While I drool over a proper Corvette LS1, I've been looking into the 5.3 LS-based truck engine.

From what I understand these engines put out respectable power. They're cheap and readily available. If I'm not mistaken the stroke is the same as an LS1, but the truck engine is heavier. This extra weight doesn't concern me much as the car weighs 4,000 lbs already.

This guy did a great job with a gen III engine into a '51 Chevy:

http://www.hotrodders.com/forum/so-s...-134710-3.html

I was reading about the generation IV engines that have active fuel management, which would be a nice feature.

Anyway, I have a couple of questions.

1) Would the active fuel management work with an LS1 intake? I have to use this intake to clear the hood.

2) Are gen IV engines hard to wire up? I've worked on fuel injection before, but it was on an old Nissan engine.

3) What should I look for when I go to the junkyard to find an engine? I know I need the ECU, wiring harness, and tranny, but is there anything else?

Any constructive comments would be welcome. As I said, right now I'm just in the planning stage.

Thanks,

Darian

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:35 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.