Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> primered fenders
User Name
Password
lost password?   |   register now

Thread: primered fenders Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-08-2010 07:32 PM
mitmaks these aftermarket panels will almost always require some bodywork. They are so thin that they get damaged during shipping. You'll be getting a panel with a little ding here and there. You can run 80 grit sandpaper on D/A sander and then use primer surfacer. No need to strip it all the way down.
11-08-2010 07:17 PM
FRANKBULLITT We just repalaced a rear quarter panel on a 2010 ford and the new panel had runs in the e coat and pock marks best to always sand and primer.This was a $1200 panel .Yekes!
11-08-2010 10:11 AM
kd5icr I would agree, always re-sand and primer new parts. not only will you see if there is any surface rust but with a new coat of primer you will see any surface damage.
11-08-2010 10:04 AM
Sick467 It definately needs to be sanded if you are shooting for a thourough and quality job. To many replacement panels have runs and paint flaws that you don't want showing up after you have painted it. And almost every one I've worked on needed some straightening by block and hammer or skim putty. Just a warning, these reprodution facilities tend to make parts in batches and I have found several that had light surface rust under thier primer from when the steel sat either prior to forming or prior to priming. I found this by prep sanding it with some 200 grit, next thing you know the black primer is popping off in places with rust underneath.

Sand it and keep your eye open for bubbles and runs.
11-08-2010 08:01 AM
docs57
primered fenders

How good is the black primer on new fenders, should I sand and primer or not?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.