Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> how to get straight straight panels ?
User Name
Password
lost password?   |   register now

Thread: how to get straight straight panels ? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-22-2011 01:34 PM
yeepman2 I would block it out with 180g then prime w/ 2k. I would then wet sand it w/400 wet. When you get a panel blocked w/400 clean it up with water and look down it while wet, If it's wavy you'll see it and the you can fix it with 2k spot putty, spot prime it and check your work again after blocking with 400. The darker the 2k primer is the easier it will be to see what it looks like.
02-22-2011 12:29 PM
turbo t
how to get straight straight panels ?

hey guys on a old mk2 rabbit resto

done all bodywork/welding ...skimed all repairs with rage gold sanded with 80g as the rest of the car

after it was all blocked/guide coated/blocked again with 80 on a long 3m purple board 16.5"

left overnight for all solvents to come out filler and applied 1 coat of lesonal epoxy primer ...followed tec sheet and applied 2 coats of lesonal pollyester primer and while wet gave it a nice dust as a guide coat leaving this in the booth for a week to flash off good


BUT

I want it straight i was always told corse paper = straight car so

lesonal tec sheet says start a 180-220 then prime with 2k

what would be the best way to go on this guys ?


thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.