Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> rear gear ratio options. s-10
User Name
Password
lost password?   |   register now

Thread: rear gear ratio options. s-10 Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-16-2003 10:49 PM
Evan Thanks, I'll try that
08-13-2003 10:55 PM
DoubleVision the 80`s line camaro, firebirds, cutlass, regal, monte carlo, all carry the 7.5 rear just as the S-10 does. you could easily find a 2.73 or higher ratio in a firebird or camaro, carrier and all, then afterwards, just swap the guts, in fact, the camaro and firebird came with posi rears with a 2.73 ratio, the codes are:
1986 2HT 2.73:1
1986 2HV 2.73:1
go to a parts store, and get the hayes manual on these cars, it`ll give the codes which indicate the ratio as well as rather or not it`s a posi. all i did when i did this swap to my cutlass was go to the parts store, took the book to the counter and wrote the codes down. if your interested in doing this, the code will be stamped on the passenger side front axle tube. the rear gear I took out of my cutlass was 2.14:1, I swapped in a 3.23:1 with posi from a 83 firebird, so as you can see, the cutlasses came with a real high ratio also. good luck
08-13-2003 10:12 PM
Evan
rear gear ratio options. s-10

I have a Th-350 in my 86' s-10. I have open wheel 7 1/2" 3:43's. I'm running 4000 rpm's at 60 mph. I would like to drop RPM to 2500, or so. I'd like to get a hold of some 2:73's, but that would require a new carrier. Could I match up a 8 1/2" 10 bolt differential to my axles and casings? Posi, or LS would be nice too. Any suggestions?
Thanks,
Evan

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:58 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.