Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Garage - Tools> Connecting cable TV from the house to the garage
User Name
Password
lost password?   |   register now

Thread: Connecting cable TV from the house to the garage Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-24-2011 06:47 AM
jetnow1 Or buy the little plastic tool to trim the end of the cable - it makes making
the end as shown very easy and is cheap to buy- found with the new connector you need. If you know anyone who is a handyman or electrician
they will have one you might be able to borrow or just have them cut the
end for you. It can be done with a knife but the right tool makes it much
easier.
04-23-2011 02:52 PM
cobalt327
Quote:
Originally Posted by HotRodMan
What I was worried about is the old cable I pulled out had the center wire protruding about 1/4 inch out of the end. The new wire I put in had that center wire recessed back in a compression connector. It screwed on to the splitter OK but I am not sure if that center wire is making contact inside since it was shorter?
Unless it's very short, it should make connection. But if it doesn't, it's a simple matter to cut and re-terminate the cable using parts from Home Depot or Radio Shack.

Prep the coax to look like the picture and twist on the terminal and you're done. If you want, you can use the crimp-on type terminals, but if used indoors, the twist on type works fine, IMO.

04-23-2011 02:17 PM
HotRodMan
Ground potential OK?

As far as the ground potential goes I have a 4 wire set up in the house, and I also ran 4 wires out to the garage so I would think I would be OK there? There is a dedicated ground going from the ground buss in the house to the ground buss in the garage.

What I was worried about is the old cable I pulled out had the center wire protruding about 1/4 inch out of the end. The new wire I put in had that center wire recessed back in a compression connector. It screwed on to the splitter OK but I am not sure if that center wire is making contact inside since it was shorter?
04-23-2011 11:34 AM
T-bucket23 You need to make sure that your detached garage is wired properly. If the ground potential is not the same as the main house your cable could end on carrying current and this is not good.
04-23-2011 06:53 AM
poncho62 Dont know what your cable is in the house, but I have seen that Cable Tv generally uses RG-59 cable and satellite TV uses RG-6 cable....RG-6 is the better cable, so I cant see you having any problems.....At my trailer, I had to put my satellite dish about 200 ft away from my TV to get a signal....I had no problem and didnt need a booster

Best to try and keep your cable away from electrical cables if you can
04-23-2011 06:16 AM
Irelands child You can have or make up as long a cable as you need. If you need a longer one, you can buy, or again, make up a longer length. Home Depot and Lowe's both have a section of connectors, splicers, cable, splitters or whatever you might need. WalMart has some as well. You might possibly need a signal amplifier too, especially since you have the older '60s cable in the house. You do not need that fancy crimper to put the ends on if you have an automotive stripper/crimper
04-23-2011 12:44 AM
HotRodMan
Connecting cable TV from the house to the garage

I have cable TV in the house that was installed way back in the 60's. There is one TV in front of the house and a second one in the back of the house with the splitter in the crawl space. Everything in the house is working fine.

I have built a detached garage and would like to have cable TV out there also. I no longer use the TV in the back of the house so I ran a RG-6 quad shield cable from the garage to the house , disconnected the existing cable to the TV in the back of the house, and screwed in the RG-6 cable into the splitter.

I noticed that the center wire coming out of the RG-6 cable is not as long as the old cable that I pulled out, leading me to believe this is not going to work.

Is the connection of the RG-6 cable to this old splitter going to work?

If not what do I need to do?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 12:06 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.