Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Oil leak between oil filter adaptor plate and block
User Name
Password
lost password?   |   register now

Thread: Oil leak between oil filter adaptor plate and block Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-23-2011 11:36 PM
Highball
Oil filter adapter plate leak

In my experience with the adapter plates some will warp just a little. Not enough to be seen by the naked eye but they do warp. I suggest you try a reputable gel type gasket material behind it where it meets with a gasket. Talk to the Parts House counter person and ask what product they recommend you try using.
Normbc9
04-11-2011 09:44 PM
cobalt327 Useful thread- http://www.forabodiesonly.com/mopar/...ad.php?t=22994
04-11-2011 06:37 PM
T-bucket23 Have you tried putting a little lock tite on the bolts that hold it on. I am wondering if they are backing out a bit after time. It doesnt make sense that if the surfaces were uneven that it would take 30 days to leak and it sounds like you have done all the normal stuff as far as sealants.
04-11-2011 05:54 PM
HotRodMan
Oil leak between oil filter adaptor plate and block

I have a 1965 plymouth belvedere II, 273 engine with a 727 auto transmission. There is an adapter plate between the engine block and the oil filter. There is a leak between the adapter plate and the engine block. I am using mobile 1 synthetic oil with k + n oil filter. I have repaired this 4 times, the repair last about 30 days and then it starts leaking again.

The procedure I used was to take the plate off, check for warpage, completely clean the engine block and plate, coat both sides of the gasket with sealer, reinstall the plate with new gasket, reinstall the threaded pipe nipple in the center of the plate, let it set up over night, installed new oil filter.


Here is what I have done.

1. New gasket between the plate and block no sealer. (This is the way it came from the factory)

2. New gasket with permatex #2.

3. New gasket with the right stuff sealant.

4. New extra thick gasket with the right stuff sealant.

Any ideas appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:48 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.