Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Burn in Clear or Re-Clear it all?
User Name
Password
lost password?   |   register now

Thread: Burn in Clear or Re-Clear it all? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
04-30-2011 06:31 AM
deadbodyman Burning it in will be tough ,you can try it but plan on reclearing.It wont work unless its done just right,first sand well past the repair with 1200 ,use an adheasion promoter,wait till the clear has dried ,sand the featherd edges back and sand the repair with 1500-2000 as you would before buffing, then buff. resanding with 600 and reclearing the whole car seems like a lot of work but it'll be worth it ...A lot of us do it even when the job looks great...
04-28-2011 06:42 PM
off2wildblue
Burn in Clear or Re-Clear it all?

Well, I cut the clear with 400 then 800. I had a spot that was in the worst possible area for a run which is by the back quarter window where the sail panel meets the quarter panel on the drivers side. Trying to get that out I burned through the clear...surprise huh? Anyway, there was a blemish in that same area that needed fixed anyway. You can see the problem spots on the first pic just below the back edge of window.

So how can I fix this?

Can I just spray some base to cover and then let it sit and then mist coat the clear and then apply two coats of clear on top of that and re-sand?

I guess that will give me a chance to practice my clear with the higher pressure anyway. However, I don't really want to do all that. I would have to spray the both quarter panels and the roof if I did this because there aren't any body panel gaps unless I tried to stop on a body line (67 Mustang).

I tried burning in clear at one time on a metallic paint job. I sucked on that one. I kind of just sprayed it and sprayed the burn in stuff from the aerosol can but I didn't have any real good advice.

Any recommendations?

SAM

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:21 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.