I have the "unlimited products" 2-1/4" cowl hood on my 65 Chevelle
because I needed clearance for my Wieand Stealth. My question is:
I would like to run the stock hood again..is there a good low intake
manifold that will perform like the high risers. My LS6 is almost done
and it was desk top dynoed at 539/565 with the Stealth, don't want to
loose those numbers. I thought of the stock aluminum factory LS6 intake,
but that is for a 70 Chevelle hood and the 70 has more clearance than the 65.
I know this is a Chevelle and engine question, but you guys have th answers.
Thanks
because I needed clearance for my Wieand Stealth. My question is:
I would like to run the stock hood again..is there a good low intake
manifold that will perform like the high risers. My LS6 is almost done
and it was desk top dynoed at 539/565 with the Stealth, don't want to
loose those numbers. I thought of the stock aluminum factory LS6 intake,
but that is for a 70 Chevelle hood and the 70 has more clearance than the 65.
I know this is a Chevelle and engine question, but you guys have th answers.
Thanks