Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Caprice Classic Clear-Coat Problem
User Name
Password
lost password?   |   register now

Thread: Caprice Classic Clear-Coat Problem Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-29-2011 03:46 PM
Old Fool It is possible you can just cut and buff the clear and get rid of the peel.

I use 3m sanding film, starting with 1000 grit and an interface pad on a da. then step up to 1200, then step up to 1500, then 3000 trizac without the interface pad, but using a bit of water to keep the pad wet with the trizac.

Other guys wetsand it by hand using the sme basic steps in grit grade.

Now buff and admire.
07-28-2011 09:43 PM
1985Caprice
Caprice Classic Clear-Coat Problem

I recently painted my car. Base coat went on nicely, until I applied the clear. Unfortunately there is orange peel on the one side, and on the hood. I am fairly new to painting cars but this is not the first car I have painted. What is the best way to resolve this issue? Do I need to re-sand and start from the top, or can I wet sand the clear and then respray the clear? As I say I am fairly new to the trade. I am using a siphon fed gun, should I be using a gravity fed gun? Any information would be greatly appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:33 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.