Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> 1937 Ford Coupe w/351 Header Help Needed
User Name
Password
lost password?   |   register now

Thread: 1937 Ford Coupe w/351 Header Help Needed Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-09-2011 09:08 AM
FASTFORD I have a Cleveland in my 34 coupe.
I installed full length headers. what they needed was one section of the tube cut out (number 7 cylinder) & a larger radius bend put in that allowed the steering arm to pass through the header.
it does make it a tad harder to remove the header if necessary but it works. then I had the headers coated after everything fit in place and run for one summer.
sorry, no pics
09-09-2011 06:52 AM
Irelands child Clark - I have a feeling that you will be hard pressed to find a long tube set of headers on this combination. With the motor mount in the center of the engine, the X member across the chassis, a below the floor master cylinder(assumed), a wide transmission just work against doing that without building them yourself. I ended up with the fourth different set of headers (Summit and I got on a first name basis on that exercise ) which were Sanderson's. And they were the shorty block huggers. I didn't want that brand and I wanted long ones as well. My steering - it's close, but with u-joints and a stand off bearing, it works. And my '31 has a much tighter chassis.



Dave W
09-09-2011 06:29 AM
37FordCoupe
1937 Ford Coupe w/351 Header Help Needed

I am building a '37 Ford Coupe with a 351W/C6 Combo, MII Front End (Rack and Pinion Steering. I do not like the Center Dump Shortie Headers and the Rear Dump Shortie Headers interfer with the steering and firewall.

Has anyone put a full lenght set of Headers in a combo like this (351w/C6) if so, which set did you use (ie 64-73 or 79-93's)

Thanks

Clark

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:46 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.