Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Interior metal floor edge against interior body
User Name
Password
lost password?   |   register now

Thread: Interior metal floor edge against interior body Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-12-2011 02:00 PM
OneMoreTime First you are probably up for some metal replacement but we know that..when you get the metal replaced apply a couple of wet coats of epoxy primer and then in the areas where it looks like water may get in like seams and such use a seam sealer to fill those voids..i would think that would do it for you..the felt looking stuff may be dried up old sealer that was applied when the truck was built..

Sam
09-12-2011 12:35 PM
55paneltrk.
Interior metal floor edge against interior body

I have a Ford Panel trk. that uses 3/4 plywood for flooring. From the edge of the floor to the interior outer skin it has metal that fills that area. The metal is broke at a 90 degree that meets the inside outer body. The original product looked like some kind of felt to fill that void. This must have held alot of moisture. Rusted out from the back of doors to rear wheels and then onto the rear doors. I was wondering what i should use this day that would work the best ? Thank you all for your input, Marc

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:50 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.