Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> camshaft gurus help?
User Name
Password
lost password?   |   register now

Thread: camshaft gurus help? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-13-2011 04:12 AM
chevy302builder18 hmmm i geuss i was wrong. but i know i can definatly do 450 foot pounds at 2500 rpms with what i got on the dyno sim maybe ill just go with that idea. Thanks for the help. Tryna build my rod for like mild which i believe 450 foot pounds and 390 hp peak would be for a 400 sbc. Hey itll also be more streetable too
09-12-2011 08:05 PM
cobalt327 You aren't gonna make 500 ft/lb torque at just 1000 RPM from a naturally aspirated 400 SBC. Ordinarily the torque and HP peaks are much closer together than what you're proposing.
09-12-2011 07:30 PM
chevy302builder18
camshaft gurus help?

ok now i have an intresting way of looking at this, my applicant idea is very simple. 400 sbc with 500 ft pounds at a 1000 rpm, (stump puller) but very flat torque like to 6000 rev limit with a peak hp to 5800 rpm. Many might say it wont do good with the 1/4 mile, but i say it will do decent with a 1/4 mile (if tractions at its best) now it is quite difficult to think of which is right for this appliction... Not to many would do it. Ok rear gear will be 2.73:1 ratio (idea is the steep or a lil lower would be great to twist with 500 ft pounds) or a lil lower. TH350 or TH400, 1500 stall or even factory. The cam shaft im looking for specifically needs to be a power band of 1000-5000ish or more rpms would be great. Any options or suggestions on how to get this application tight like that? Thanks and sorry about this if its annoying question, pretty sure you guys have better things to answer. Im really wanting to make it right on par

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:49 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.