|09-18-2011 03:32 PM|
Thanks a bunch, it all make sence, now that it is back together!
There was a clip for the piston but the outer one I just used some old disc brake quite I had left over from my "new 78" chevu pick up.
When I put it together the first time I thought it was for the pad to keep it from squeeking, so I had both of them installed different!
I was changing front tire size so now was the time to address the orginal problem................... THANK YOU !!
|09-18-2011 02:59 PM|
It keeps the caliper from clunking around when hitting bumps.
There should be anti rattle hardware with the pads, unless you got the cheapies, but you may be able to get it seperatley.
There is also an adhesive that can be used on the pads backing to keep them fixed tight to the caliper, but I prefer the proper clips.
|09-17-2011 07:14 PM|
O K, so what keeps the pad tight in the caliper, if it goes on the outside?
There appear to be a bit of clearance on the pad between the anchor and caliper. I thought this frog leg was to keep it from squeaking!
I tried that and it fits BUT what is it supposed to accomplish?
|09-17-2011 06:16 PM|
|LATECH||In cobalts post, pic #2 shows it pretty clearly|
|09-17-2011 06:11 PM|
Put the O s in the X s
then flex the spring into position where the arrows are
The clip should be on the outside of the caliper not between the caliper and the pad.
The third pic is close, just flip the spring/clip over put the arrows in my pic together on the caliper mount.
|09-17-2011 06:03 PM|
The ends go in the holes in the caliper that are clearly visible.The loops go over the caliper mounts.
They do not go between the pad and the caliper.
|09-17-2011 04:02 PM|
It still dosen't look right!!
|09-06-2011 08:09 PM|
Don't know how well it shows up on your monitor, but the two ends locate on the caliper, where the 'divots' are. Then the clip acts as a 'bail' to capture the outer pad.
|09-06-2011 12:40 PM|
Now we are getting closer!!
Outboard pad spring.
Ok, I will see if I can orientate it in the right direction!
|09-06-2011 11:00 AM|
2WD CALIPER ASSEMBLY
FRONT BRAKE AND SPINDLE ASSEMBLIES
There may be more than just one caliper used, depending on the year by the looks of things. The top caliper above uses an attached clip while the bottom caliper above (and the 4WD caliper, below) shows a separate rattle spring/clip affair. In any event, you can see the orientation of it.
4WD CALIPER ASSEMBLY
|09-06-2011 09:55 AM|
Everything on this truck came out of a box!!
I did not have one to look at it is all hand built, so I need a picture of one side to build my front brakes.
Thanks for the pic but it is on a 6 lug caliper and rotor which is "newer" than my 5 lug
|09-06-2011 09:55 AM|
|09-06-2011 08:21 AM|
|cobalt327||This is why it's a good idea to take apart one side at a time.|
|09-06-2011 05:31 AM|
|mmopar0521||This is the later style, but I think it is the same. Hope it helps.|
|09-05-2011 09:59 PM|
|solidaxel||ANYBODY, have a picture of Dodge Dakota 89 caliper so I can see how the "cricket leg" attaches to the disc pad?|
|This thread has more than 15 replies. Click here to review the whole thread.|