Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Interior> Does anyone have a 51 chevy truck seat bench for a custom cab
User Name
Password
lost password?   |   register now

Thread: Does anyone have a 51 chevy truck seat bench for a custom cab Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
10-23-2011 09:29 AM
MARTINSR Unless you find a VERY thin seat go over the top. But the raiser is about 6-7 inches tall at the front. Most every seat is designed to sit flat on the floor. HOWEVER most later model seats are a lot thinner because the bodies of the cars go thinner. So a bench seat from a 67 Chevelle or something like that may work being they were MUCH thinner than a seat from a 1950 car or truck.

My truck had a chopped top, so that changes things a little. But I am not a tall guy and when I put 65 GTO bucket seats in my truck I removed the raiser and they worked PERFECT for me.

Brian
10-23-2011 12:02 AM
Youngelf7 So i need to completly remove the welded in raiser
10-22-2011 11:51 PM
MARTINSR The hard part is the raiser that the seat is one is welded to the floor. So you have to drill out all the spot welds and remove it before you can bolt in another seat. I did it once and it really wasn't that big of a deal. But you will need to do this to put another seat in.

Brian
10-22-2011 05:44 PM
Youngelf7 Thanx for the advice i will try that if i cant find a stock bench
10-22-2011 05:18 PM
OneMoreTime For something like that I would take some measurements and then go to the pick-a-part and look for the mid seat out of a van..those seem to work ok.

Sam
10-22-2011 04:42 PM
Youngelf7
Does anyone have a 51 chevy truck seat bench for a custom cab

Im looking for a 51 chevy truck bench seat,or any other suggestions of a truck bench that will fit inside of a 51

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:25 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.