Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> Computer controlled to standalone
User Name
Password
lost password?   |   register now

Thread: Computer controlled to standalone Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-06-2003 01:18 PM
Forsaken502 Thanks for the info. I intend to use the distributor off the 350, but I bought a new rotor, cap, coil, and wires to freshen it up. If it worked on the 350 before, hopefully it still will. I'm going to strip the old distributor and use it as a primer for the engine oil. Since I don't know where the chip is, I'll just remove the light.

Any one know if I can take the computer out all together? or does it control other devices as well (I'm using the tranny from the non-computer controlled vehicle, the one that originally came with the 350)
09-06-2003 04:34 AM
DoubleVision as far as your swap goes, you`ll need a older HEI with vacuum advance and mechanical advance, as the computer controlled HEI used the computer to advance the timing and had no mechanical advance. as far as the gauges go, the sending unit should bolt right up to your 350, as the 305 and 350 blocks are only different in bore size. I installed a Rallye pak gauge cluster in my 86 cutlass from a 82 cutlass calias, I had to swap some of the wires in the harness around, and all I did for sending units was get ones for a 85 camaro Z28 that had a rallye pak. GM sending units are pretty much the same. the sending unit for oil pressure should be in the rear of the block by the distributor, just install the one you intend to use. as for the check engine light removing the bulb works, but in my 86 cutlass, a friend removed a chip from somewhere behind the glove box and the light went out.
09-06-2003 01:43 AM
Forsaken502
Computer controlled to standalone

I'm replacing the computer controlled, 4 barrel 305 in my car with a "standalone" 350. Anyone know what problems I may encounter? How will I keep the "check engine" light from coming on? (just remove the bulb?) I'll be getting a set of gauges (oil press, water temp, alt. charge) so I'm not too concerned about the warning lights because I can moniter the gauges.

Also, the 350 has a mechanical oil press sending unit and the 305 was electrical. How do you replace a mechanical sending unit with an electrical one?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:24 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.