Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Transmission - Rearend> remove yoke from10 bolt rear
User Name
Password
lost password?   |   register now

Thread: remove yoke from10 bolt rear Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
11-09-2011 10:05 AM
speedbump Remove the large nut and washer and tap or use a puller to get the yoke out. It isn't press fit so it shouldn't be too hard. The install can be really tough to do right, as right would entail removing the seal, outer pinion bearing and crush sleeve, installing a new crush sleeve and re-tightening the "new" pinion nut to get the proper preload on the bearings. That said, I have done it on the cheap by counting the number of turns it took to get the nut off by using punch marks on the nut and pinion shaft end put there before loosening the nut. IF you use the old nut, you then can put it back the same way using red loctite and line up the marks + a small amount on the nut when you torque. Don't be afraid of 125-150 foot pounds to get this. IF you are just replacing the seal this can work well provided you are clean and methodical in your reassembly. IF you are also replacing the front bearing, it gets more complicated as the crush dimensions can change. I'm not advocating this method for the inexperienced, but it can be done with satisfactory results. Your results may vairy.
11-09-2011 09:22 AM
30chev
remove yoke from10 bolt rear

how do i remove the yoke from a 10 bolt gm rear, and how to reinstall it

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 03:32 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.