Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Garage - Tools> Air line plumbing question
User Name
Password
lost password?   |   register now

Thread: Air line plumbing question Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
12-27-2011 06:30 AM
spikebot 81 Water will form at a low point in the piping system. So if you have a pipe running horizontal and a vertical drop to a work station you will need a low point drain. If you have 1 or 10 low points you will need a drain for each low point in the system. Most larger air systems use air dryers but theses are spendy and not very practical for home shop use. The amount of water in the system depends alot on ambient air temp and how much compressed air being used.
12-26-2011 10:09 PM
Warhammer
Air line plumbing question

I have a question regarding plumbing for air lines. Im going to put a 60 gallon compressor in a storage room adjacent to my garage. The room is approximately 10 long by 4 wide. The compressor will be in approximately the middle of the back wall of the room to the left of the door. I was thinking about running copper lines around 3 sides of the top of the room. Essentially the copper line would go up the wall by the compressor, then down to the corner, across the 4 wall, then up the other 10 wall across from the compressor. Then I was going to just return it along the same path a foot or so higher. It would be similar to the setup shown here, except it will travel 3 walls instead of 2. I would really like to keep all of the drains together on the wall beside the compressor, so I was thinking of just putting a drop with a ball valve at the start of it, eg where the compressor ties on and slope the bottom run back towards that drop. The top run coming back to the compressor would also have a drain drop like shown in the diagram I linked. Basically, I would be eliminating the drain drop shown in his section 1, in favor of a drain drop where the piping begins. Would water still drain back towards the compressor against the air flow direction? Or would it be better to put the drain where bottom run ends, as shown in the drawings?

Would this work as well as the vertical manifolds like in this thread?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 11:21 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.