Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> Sealed Powers 1235M cam bearings versible application?
User Name
Password
lost password?   |   register now

Thread: Sealed Powers 1235M cam bearings versible application? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-03-2012 11:19 AM
Mr. P-Body For spring loads up to about 200 at the seat, the 1235s are fine, as said.

For SERIOUS cams/springs (>200 at the seat), use DuraBond "High Performance" cam bearings. The part number is CHP-8. Until one is to replace them with "roller' cam bearings, these are the very best.

Jim
01-01-2012 10:44 AM
techinspector1 I don't think anyone's stumped, it's just that cam bearings aren't very sexy. Those bearings will work fine for a roller or any other camshaft.
12-31-2011 03:18 PM
chevy302builder18 Hmm everyone seems stumped also... Im going to more research into these bearings
12-30-2011 10:45 PM
chevy302builder18
Sealed Powers 1235M cam bearings versible application?

Yea the title asks all, ive googled these, which i purchased for $18 and i was checking em out if they could support a nice heavy load of a roller camshaft. Seen a couple build articles, that used these bearing but im not sure.... Could you tell me if they will? Thanks.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 07:41 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.