Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Suspension - Brakes - Steering> Disc/Drum Sizes and Valving
User Name
Password
lost password?   |   register now

Thread: Disc/Drum Sizes and Valving Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-08-2012 10:09 PM
matts37chev I am no expert
but I would just go with what you have
bigger drums are always better
then tweak the system later, if you have to balance it out better
maybe someone with more of a working knowledge, of how that combo will work, will chime in
01-08-2012 09:30 PM
redsdad
Disc/Drum Sizes and Valving

I am about to run my e-brake cables and I kinda hit a snag. I am not sure if my rear drums are the size I want. Looking for input from folks with similar experience.

Car is a 41 Chevy 2 door sedan. 350/350.

The booster is an 8 inch dual diaphragm. The pedal ratio is about 4.5:1. Corvette style MC.

The front brakes are 11 inch rotors with metric calipers (2-1/4" (?) piston).

I thought the rear was out of a G body. It is definitely GM and it has the mounts still there for the upper trailing arms. I never looked at the brakes that close and assumed they were the 9-1/2" brakes. When I started fitting up the e-brake cables, I realized the rear had 11" drums. The rear wheel cylinders are 15/16" units.

I intend to run a GM style combi valve (metering, rear wheel residual pressure, proportioning, and differential pressure switch).

My question - Will the 11 inch rears cause brake balance issues? If so, should I:

1. Switch to 9-1/2" rear drums?
2. Put an adjustable proportioning valve in the rear line?
3. Set it up and test it, putting in an adjustable proportioning valve only if needed?
4. See if I can find some smaller wheel cylinders which will fit the backing plate (7/8" or 13/16" maybe)?
5. Combination of the above?

If I go the adjustable proportioning valve route, do I remove the proportioning valve from the combi valve or just run them in series?

What do you think?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 08:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.