Hot Rod Forum banner

47 chevy coupe

3K views 2 replies 3 participants last post by  ThatBoy! 
#1 ·
hey everyone, im building my 47 chevy coupe with original frame and i would like to use the original spindles but i want to update my braking all the way around, i'm probably going to use a camaro rear. i would also like to put disk in the front so...my question is - without spending top dollar for a disk break kit what other years of breaks would fit my spindles and where would i get the right callipers, bearings and spacers? any info would be helpful......thanks
 
#2 ·
SoCal1 said:
hey everyone, im building my 47 chevy coupe with original frame and i would like to use the original spindles but i want to update my braking all the way around, i'm probably going to use a camaro rear. i would also like to put disk in the front so...my question is - without spending top dollar for a disk break kit what other years of breaks would fit my spindles and where would i get the right callipers, bearings and spacers? any info would be helpful......thanks
Best place I know for what you need. Here's the link to the front disk brake kit. Chevy's of the 40's

Centerline

HotRodsAndHemis.com

"When buying a used car, punch the buttons on the radio. If all the stations are rock and roll, there's a good chance the transmission is shot." - Larry Lujack
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top