|02-08-2012 05:26 PM|
the hub that goes down at the bottom of the case on assembly is also staked and ive seen at times the output shaft doesnt go in all the way by hand and have had to take a rubber mallet to tap it in all the way.
|02-08-2012 09:18 AM|
700r4 output shaft
i am rebuilding my 700r4 and have ran into a problem. my output shat will not go all the way in. i am not able to get the snap ring into the groove. the shaft only needs to go in about another half a cm. maybe i have a bearing or thrust washer in the wrong place? anybody with any suggestions, please help.