Hot Rod Forum banner

Is my Valve Guide cutter broke?

2K views 4 replies 2 participants last post by  zildjian4life218 
#1 ·
I was cutting down the valve guides on a set of vortec heads today and I noticed it seemed like I couldn't keep the cutter seated. Its a Comp-4726 cutter.... any ideas what could be happening? I have always set the drill to a slow speed and used lots of cutting oil when I used this.
Thanks everyone!
 

Attachments

See less See more
5
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top