Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> Has anyone had problem with Dupont Hot Rod Black Paint??
User Name
Password
lost password?   |   register now

Thread: Has anyone had problem with Dupont Hot Rod Black Paint?? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-21-2012 06:16 AM
deadbodyman It could also be water and/oil in the air supply...check the compressor and filters ,make sure its all drained before you start...and those tiny little oilless ones are the worst they get so hot they shoot water out everywhere.
06-19-2012 02:50 PM
MARTINSR This is certainly not something limited to that particular paint and clear. But if those crevices aren't perfectly clean the paint being applied over it can shrink up as it flashes it solvents and pull up off the bottom. Or, it isn't the paint or clear at all at fault but the previous primer that was applied and it was applied over something questionable and when the paint and clear solvents get into the primer a little (if it isn't fully insoluable as many undercoats are) it can lift up off.

But it is likely simply too much material applied and it is shrinking up.

Brian
06-19-2012 09:54 AM
36 Ram
Has anyone had problem with Dupont Hot Rod Black Paint??

Hi, I am new to the site so please excuse me for not doing something or doing too much. Here goes.
A friend of mine has painted a car with DuPont Hot Rod Black (99K) and Flat Clear (2370S) and in the seams it appears to have some bubbles or is lifting away from the body, not many, just here and there. This has never happened before to him. Always used DuPont. 1st time using the above paint 99K & 2370S clear. Can anyone enlighten us? Has anyone used this paint & had the same problem?? Looking forward to seeing if anyone had the same problem.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.