Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> sbc 327 wont crank after new distributor install
User Name
Password
lost password?   |   register now

Thread: sbc 327 wont crank after new distributor install Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
07-15-2012 12:54 AM
pacman350 yes im getting 12 volts to it, problem solved the module had burned up, i got a module off another sbc that i have and put it in and instantly fired up the bad module even smelled burnt. thanks for you reply SSedan64
07-14-2012 11:30 PM
SSedan64 Are you getting full 12V+ to the Distributor?
07-13-2012 06:57 PM
pacman350
sbc 327 wont crank after new distributor install

I have a 64 sj sbc 327 and about 2 months ago i replaced the original 6 inch balancer with a 8 inch balancer that had the timing mark 10 degrees before the keyway and the original was 2 degrees before the keyway. i bought a chrome bolt on timing pointer for it. I replaced the the distributor because it was the computer controlled one that i replaced with a new vacuum advance one. So brought the timing mark on the balancer up to zero and it was on the compression stroke because i had the driver side valve cover off and both #1 valves was closed and i heard the air go past my finger. The problem is now it wont fire up at all but it will turn over i even swap the new coil for one of my dads truck and stilll same thing so i put the new coil back in. i checked to see if it had spark and it had a very weak orange spark. what do you think it can be the car is a 84 cutlass could the ignition switch do this. Its a all new distributor and the motor only has about 800 miles on it since a complete rebuild in march of last year.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 05:42 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.